Thank you for the continued assistance Jacob.
For the time being I am going to start trying to access the Revit API through a dynamo python node to assign boundary conditions to specific nodes. If I were able to do this I would not need to build the model in robot at all.
This task has been discussed with limited success in these threads but I hope it will give me a decent starting point.
- Original Boundary Condition Placement With API Question
- Damiano’s Attempt
- Dani’s Question That Went Unaswered
Additionally I’ve been gathering all of the relevant Revit API through Dynamo information I can find to set myself up for success. I found the Office Hours you held to be very helpful and I will definitely watch that one through a time or two more.
I greatly appreciate the time you’ve given me thus far and hopefully I’ll be able to develop my workflow without too many more questions