Place Family along slope pipe

[Nissal]

Hi,
I have pipe with slope of 1:100, 1:50 and 1:25.
I want to attach a support family all along the pipes.

How should i start with it? any ideas or suggestion

[salvatoredragotta]

@Nissal Start searching this forum.

Then let us know where you get stuck

How to get help on the Dynamo forums

Here are some more additions. First, do not ask anyone to do your job! This is a help forum to ask for help with things that you cannot figure out on your own, but actually tried. Most important, please remember always come back if anyone is trying to help you. If your graph provides you an error messages, please reveal the content of it as a part of the image. Please put ‘Watch’ nodes and notes in the graph describing what essential parts does. The notes will help you to remember what you did…

[Nissal]

I had already posted a topic. But i didnt get any response.
I know it is forum, not to get my job done.

I was figuring out where I did wrong or my whole network is wrong. So i have created another topic

Element.Setparameter- Apply progression or series as offset

Hi, I have slope pipe and putting supports over the sloped pipe. but those supports are coming horizontal. I tried to add offsets as per the slope. but not able to fit it in Element.Setparameter start and end offsets are of pipe; then i have calculated at what offsets those supports should come [dynamo%201] [dyanmo%201%202] im adding those start offset + the vertical distance [dynamo%202] [revit%20file] [rvit%20pipe] I hope you understood. All your help / suggestion is appreciated.…