How to run or draw conduits in model by revit dynamo using their z coordinates

Lacing should be longest not cross…

tried that also

hello, trying to remove your list.create node and branch directly from List.flatten node output

Cordially
christian.stan

1 Like

ok tried but that is also not working

try with this one here from clockwork could probably work

1 Like

ok i will trey with this one

The conduit node expect list that way

1 Like

hello, oops, I didn’t know, I don’t do piping very often. sorry Cordially christian.stan

1 Like

all family type category shown in which pkg

Clockwork

again sam e problem :smiling_face_with_tear:

whats happend when you draw a conduit manuel…its a little bit strange becoarse you will always have at least one conduit as it a systemfamily…hmmmm arhhh i see it isnt the right clockwork node you use…family types off category

1 Like

ok thanks now it works

1 Like