Find the z value of floor above

[Cem_Altineller]

Hi,
what I am trying to get is this:

To generate a beam from the placement point of a room vertically and write the Z value of structural floors lower edge.

Is it possible to generate a vertical beam from a room and how is my question.

Best regards

[bvs1982]

@Cem_Altineller

Is it possible to generate a vertical beam from a room

Pretty sure it is possible.

@Cem_Altineller

and how is my question.

What have you tried so far?

How to get help on the Dynamo forums

Here are some more additions. First, do not ask anyone to do your job! This is a help forum to ask for help with things that you cannot figure out on your own, but actually tried. Most important, please remember always come back if anyone is trying to help you. If your graph provides you an error messages, please reveal the content of it as a part of the image. Please put ‘Watch’ nodes and notes in the graph describing what essential parts does. The notes will help you to remember what you did…

[Cem_Altineller]

Already found what I was looking for:

Identify floors just below rooms

Hi All, I have created all the finish floors for my project and need to transfer room data into them but I couldn’t find a way to identify what floors belong to what room. I have tried to identify them by using the room boundaries node but floors are not included in the results. Any idea how to achieve this? Thanks!

Thanks for the input!