This was asked in 2019 but got no replies…
Question in 2019
So I’m asking again…
Can I turn off the axis lines?
But leave my geometry.
Not at this time. 
1 Like
For now you can work around the issue by translating the geometry on the Z axis so the min point of the bounding box is something like +11 and then draw a large rectangle normal to the Z axis at an elevation of 10, patch it, and set the color as desired.
3 Likes
haha great hack 
2 Likes
Or just offset all the geometry by 100 or so and then you can’t see the axis?
2 Likes
Also works, but I like to keep ‘near the origin’ to assist display navigation and manual point adjustment (automatic run mode for the win).
1 Like