Topography from excel points

Revit
1

Hi everyone.
i am facing a little bit wierd Problem which is :i am creating Points in Dynamo from excel file(X,Y,Z) then am creating Topography from those points in Revit.
Problem: my problem is as show in the pictures below that the number of created points in dynamo from excel is 166 point which is right ,but the number of point in created topography are only 126 instead of 166. anyone knows why revit reducing the number of points .
Thanks in Advance !!!.

grafik
grafik.png1580×475 110 KB

grafik

2

Hey,

No, apologies… If you try a small topo, say 10 points… Does it do it? I know that sometimes Revit ‘simplifies’ topography made just from points as it triangulates them… and then i need to go back and cut bits out again… maybe something similar is happening?

Hope that helps,

Mark