Section view along curve

[milan.nemec]

Hello,
I want to create section view on curve. I extract V isocurve and create plane in parameter on it. Then I create coordinate system on plane. I want to create section view by this plane or coordinate system, but I always got error. Min and max point are generated by coordinate system. Have You any idea where is error ?

[Kulkul]

Hi @milan.nemec

Refer this post:

Creating Curved Cross Section, Bridge Engineering

You could split your bridge centre line into a series of chords, create a section at each chord, and finally place the sections next to each other on a sheet, to get a “developed section”. [image] In this case I snapped the sections together by their crop box, but I’m pretty sure you can create some custom logic that snaps them automatically. [image]