Point lies outside of Revit design limit

Revit
1

I am trying to create some curves at some distant location in Revit, but it fails due as it’s outside of Revit design limit.
I can see the FamilyInstace.ByPoints node working fine in this case.

Is there a way to create these curves in Revit while preserving their coordinate values? Perhaps by changing survey/project base points?

image
image1627×528 111 KB

2

I think you have your Base Point and Survey Point mixed up. Transpose the coordinates between (swap position) them and try again.

3

Hmm… if I try to move the Project Base Point to that location instead of Survey Point, it gives the similar kind of warning in Revit (can’t be outside 10 miles / 16 kms).