Hello everyone… i am just beginner using dynamo and revit… i have question to solve my stuck problem… Is that possible to put two rotation parameter (ex : XY and ZX) in one point reference to make a profile/family then rotate them based on two plane (XY and ZX) ? The aim is to make the profile/fam…

First create adaptive point for the xyz coorrdinate second select XY plane of adapptive famiy and insert referanse point. here we defined xy plane angle then select vertical plane of the “XY referance point” (not adaptive point) and add another refrrance point "XZ point " host by “XY referance poi…

[image] Rotate Adaptive 3 Points Family arround X-Axis and Z-Axis Revit Thank you for your reply @RMohareb I have revit 2021, so I can’t open your files frowning I placed another ref. point but still can’t rotate XZ Plane. [Tunnel_script] [tunnel_1] [image]

Thanks for your answer Sir. I have seen and try to analysis your profile (like in image below), but I’m still confuse how to create two rotation parameter in same point when make a profile? Would you to elaborate how to make them sir? thank you [Moharebs profile] is the principle like this ? c…

to calculate these angeles you can use the node to get the coordinae system [image] or [image] from Brimohareb_XX pak.

Ohyaaa… it works!! i did’nt think of that before… Thanks for your answer Sir

Yeahh i have an issue to measure the angle in dynamo too (i have measured the angle of coordinate system X axis from my point reference and X axis in global along the route using angle about two axis but the result is 0 so there is no rotation and also there is a problem that i have to solve)… I wi…

Is that possible to put two rotation parameter in one point reference while making family profile?

Revit

RMohareb March 8, 2024, 10:40am 2

Topic		Replies	Views
Rotate Adaptive 3 Points Family arround X-Axis and Z-Axis Revit revit , dynamo	13	1419	May 2, 2023
Rotate family around custom vector Packages	4	1371	October 2, 2015
Rotation 2 point adaptive component Uncategorized	0	414	June 9, 2020
Rotation about three-point adaptive family Geometry dynamo	5	752	December 23, 2019
Rotating Revit family in two Planes simultaneously Revit	5	234	June 12, 2023

Is that possible to put two rotation parameter in one point reference while making family profile?

Related topics