Interior Function Wall Tops Offset set by Floor Thickness

I am able to set all Wall Top Offsets to Floor Thickness. What I am attempting is to set the Wall Top Offset of only Walls with the Function set to Interior. Where am I going wrong?


This will filter your list of walls into interior only. Just feed you floor thickness into value. I assume your next step is to determine which interior walls are associated with which floors.


Thanks Tim for the reply. It’s getting closer but it seems to be ignoring some of my walls. For instance, there are 33 walls in my Watch list but only 4 are listed after the GetParameterByName(Type or Instance) Node. By the last Node it’s down to 2 walls. Any ideas?



Ok, I think the Rythym node was throwing it off somehow. When I edited the graph as below it worked.