How to panelize/ divide a polysurface evenly

Packages
,
1

Hi Everyone,
I’m trying to panelize a complex surface. I’m using a .SAT file exported from a rhino file. When Imported to Dynamo, the Geometry.ImportFromSAT node outputs 960 surfaces. I managed to create a polysurface and apIy the panel nodes contained from the lunchbox package, but the result I get is panels of the 960 sub surfaces and the total surface (see image below). Could someone help me figure out how to proceed ? Thanks

image
image.png1614×892 189 KB

Dynamo script.dyn (3.3 KB)
2.sat (2.7 MB)

2

I wonder if this thread might be useful?

Good luck,

Mark

3

@R.H Hope this approximation serves your purpose
satPanel.dyn (38.7 KB) (ver 2.1)

satPanel

2 Likes