HELP PLEASE! How do I achieve the following example on a REVIT wall using DYNAMO?

1

I’ve been trying to emulate a lot the examples on this forum but I’ve been unsuccessful.

Untitled%20presentation
Untitled presentation.jpg960×540 41.1 KB

2

Have you done every exercise in the primer yet?

What graphs have you tried? Can you post where you got stuck?

The forum typically provides better results when you provide what you’ve tried, and even if you were given a wonderful graph it’s not likely to be 100% perfect for your situation, so some degree of knowledge will be required.

1 Like
3

Untitled%20presentation
Untitled presentation.jpg960×540 30.1 KB

Thank you for your response! In the above picture I redrew the wall as a mass and I’ve been using the script to try to make it an adaptable surface.

Is there another way I can do this? The goal is to have rotating louvers on my wall in Revit.