I used the geometry intersect with plans, and the result as you can see from the second picture. I just got half of the surface. I don’t know what’s wrong.
!
I used the geometry intersect with plans, and the result as you can see from the second picture. I just got half of the surface. I don’t know what’s wrong.
I used the geometry intersect with plans, and the result as you can see from the second picture. I just got half of the surface. I don’t know what’s wrong.
post your graph and/ or your files pls…
ExcelPoints.dyn (33.1 KB)
point.xls (49.5 KB)
@Fiesta
your “workspace of geometry” is to low…set it to the highst…
or just reduce the points from 100000 to 1000
Thank you very much.
pls mark my post as solution:)