Cable Tray fitting using MEPFitting.ByPointsAndCurve

[Kulkul]

Hi @Claus_Andersen

ListOfPoints needs atleast 2 points currently you’re feeding 1. Refer this post:

Help with MEPover MEPFitting By Points and Curve

Hi Andy, Try setting your run execution to manual instead of automatic. I would recommend doing this for any other graph as well. After that try setting your lacing on Curve.PointAtParameter to Cross Product. Dynamo 2.0 seems to work a little different with the lacing when compared to 1.3, whereas in 1.3 you could set it to longest and get the same result. Here’s the result I get with an extra duct (then you can clearly see the required ListOfPoints per duct) and the lacing set to cross produ…