I am trying to place a 4-point adaptive family using dynamo. I have a list created with 4 points listed (x,y,z axis), but instead dynamo is taking each point and placing 4 families at each point, I can not figure out what I am doing wrong. Any suggestions would be much appreciated! [image]

You’ll need an AdaptiveComponent.ByPoints node instead of a FamilyInstance.ByPoint node. Also your list of points must be two dimensional, so you’d want a List.Create node after the flatten node. Note that Topology.Verticies and Vertex.PointGeometry might be a better solution than Surface.PointAtPa…

4-point adaptive family

Geometry

Draxl_Andreas July 31, 2023, 11:30am 2

@karolinaXEP

check out this…

Andreas

2 Likes

Topic		Replies	Views
Placing AdaptiveComponent.ByPoint Lists-Logic revit , python , dynamo	3	364	September 23, 2021
Problem placing 2 point adaptive family Revit	21	2396	April 22, 2020
AdaptiveComponents.ByPoints : The Argument have issues Lists-Logic dynamo	6	982	July 2, 2019
Adaptive component placement	4	669	November 22, 2021
How to insert Panel(based on 4points, Made by Quads from surf Node) into Revit Packages	1	617	December 7, 2014

4-point adaptive family

Related topics