I want creat a face wall by a face of wall. But even I creat mass surface by Directsharp.ByGeometry,it’s not work. Shoud I change a nodes? [image]

Have had a total of 15 minutes for stuff like this today, and I think I have resolved it. :slight_smile: The method used in the Springs.FamilyInstance.ByGeometry node which creates the initial family instance. Never poked into this before, but it’s really genius how it works in both it’s simplicity…

Hey, It’s working here? [image] Maybe try with a very simple mass to see if that works? If you hover over the top of the yellow node it’ll tell you what the warning is, maybe tell us that? Hope that helps, Mark

It might be the same problem I had a few weeks back: Create Walls using Wall.ByFace from a DirectShape Mass In which case, for some reason any mass created directly through Dynamo is not a valid mass face for use with API or Wall.ByFace nodes. However, they can still be used within Revit using the …

That’s odd… it worked here? [image] Wall By Face From Dynamo Surface Revit I’m not sure the wall by face is going to give what you want, but it doesn’t seem too strenuous… [image]

Hmm I just left the office but I will try again using your work flow tomorrow.

I just replied on your other thread :slight_smile: I also get a fail…

I would need the current graph and the associated rvt (even if its a blank file as the template isn’t engliahed based so I wouldn’t know what to pick from the drop downs).

I tried a graph similar to the one in that thread. Same error. This is the error I get when I try to use faces created by dynamo generated mass/generic model elements: Warning: Wall.ByFace operation failed. The selected face cannot be used to create a wall. Please use a mass face instead. [marks…

I think I am a bit lost. The family generated by the springs node is a free form element, but I can still explode the geometry to get faces. And the faces pass as a valid reference for wall by face and will work perfectly fine using the built in tool, but it fails when using API. The workaround at …

Could you enlighten us with some images of the solution you found … since I can’t understand what you describe, thank you.

Three years back is greater than my available records. What are you after?

Wall by face error! help .even have mass face

Uncategorized

Mark.Ackerley March 13, 2019, 10:08am 4

That’s odd… it worked here?

Topic		Replies	Views
Create Walls using Wall.ByFace from a DirectShape Mass Revit dynamo	8	3070	October 3, 2019
Wall.ByFace operation failed Geometry revit , geometry , dynamo	5	451	August 19, 2022
Create Wall by Face Not Working in complex geometry? Revit clockwork , dynamo	5	1360	December 15, 2018
Dynamo mass and revit wall by face Uncategorized	19	10576	December 31, 2021
Wall.byface failed Geometry revit , dynamo	10	1066	October 4, 2018

Wall by face error! help .even have mass face

Related topics