Urban Plannig via Dynamo (BiMorph Curves from CAD Layers)

[Mark.Ackerley]

Hey,

I don’t think you can properly host them, but you can maybe use a raybounce then move them up that distance, a bit like this thread?

Distance between point and surface above

Hey, it looks like you’re not too far off… Have a look at this: I think you’d be better getting a room location rather than a 2D (view specific) spot height. You’ll want any 3D view which shows the room and the ceiling/roof to plug in. When you get the points you’ll probably just get the distance between 2 points, Hot Gear and GIS2BIM have that node. Hope that helps, Mark Edit: Like this… I was a bit wrong, only certain 3D views will work and I couldn’t see the logic for which… And you …

A randomise node could improve the naturalism of the heights.

Hope that helps,

Mark