Spot Elevation

[Ewan_Opie]

Hi @TurtleWolfe

Setting the Sketchplane before Point selection should ensure that users are selecting points relative to the view content

Is it possible to prompt pickpoint in revit section view from dynamo?

Use the :snowflake:_Set Sketchplane By View node and then the :snowflake:_Pick Points on Workplane from the Sastrugi package, as it uses the same Pickpoint method with a reset function. Setting the sketchplane when the Active view is the sheet before picking the points should do the trick You can use the Passthrough node from the Clockwork package to force the run order.