Spline to arcs and lines?


#1

Hi everybody!

I’m trying to rationalize a spline in order to make it convinient for fabrication. I am using the LunchBox Curve to Arcs by Division node which does great work.

However I am wondering how i can divide the spline into a given number (or given size of every element) of both arcs and lines. Every element (tubes) should be tangent to the next.
I am open to suggestions :slight_smile:3


#2

See if this helps…

20151012-1


#3

I have actually tried the Curve.ApproximateWithArcAndLineSegments but it has no control over the approximation. I end up with too many too little arcs and lines