Spline floor boundary error = Dynamo/Revit crash


#1

Hi,

I’m new to the Dynamo forum, so hello to everyone!

I try to get the geometry of the Revit floor that contain one (or more) spline as the boundary (see picture below). It ends every time with Revit crash.

Is this a known issue?

dynamo_error2

dynamo_error

 

 

 

 

 

 

ps. some dynamo definitions also crash even if they refers only to structural columns without using any slab information. After removing all the spline-containing slabs, the definition runs without errors.

Kind Regards,

Jarek