Hello everyone. I was asked if I could adjust the Reinforcement cover settings for all the elements in our project. I was asked to amend it to say “REFER TO NBS CLAUSE” I initially thought that this would be a very simple case of Element.GetParameterValueByName followed by Element.SetParameterByNa…

it does the same as the Element.Name node - gets the name from the element

Rebar Cover Settings

Einar_Raknes July 7, 2017, 1:03pm 6

here you go:

2 Likes

Rebar Cover in Walls

Topic		Replies	Views
Value of Parameter Rebar Cover output Revit	3	746	December 16, 2020
Change rebar length Revit	7	798	August 25, 2021
Changing Read-Only Parameters Revit	7	3749	June 7, 2017
Set parameter value connection	6	1447	November 16, 2019
Multisheet Edit Sheet Parameters Revit revit , dynamo	3	728	June 18, 2020