Pipes from point clounds

[RJK42]

Hello,

I am new to Dynamo and looking for a way to have Dymano assist me in creating some piping from a point cloud. I would just like to start off my crating sections of runs for verification. I’m not looking for Dymano to draw every pipe but I would like to section the cloud where I would need to have modeled so that I can verify it in Revit.

Thanks

[Manel_Fernandez]

Hi there, look at this post

Point cloud to dynamo to revit

Hello, I am working on modeling a warehouse from a pointcloud in revit, I would like to see if it’s possible to bring the point cloud through dynamo into revit and have it do most of the legwork for me. Can someone point me in the right direction please?

Cheers!