Hiya! When I am generating a NURBS Curve from a coordinate system, it seems to be at a ‘lower resolution’ than the other curve that is generated. Have a peek: [LowResNC] As you can see, the curve does not go through each point, but rather every 5 or so. I have previously generated this before a…

NURBS Curve At Low Resolution?

Kulkul October 22, 2019, 7:21pm 2

Change Geometry Scaling Settings to Medium and it should be fine:

Solid by Loft problem

Topic		Replies	Views
Smoothed curve through points Uncategorized	6	883	April 14, 2022
NURBS Curve from Dynamo to Revit Geometry	1	1060	September 1, 2019
NurbsCurves not the same length Uncategorized	9	411	February 23, 2019
Interpolated Curve Issue Geometry	12	1726	January 20, 2017
PolyCurve.Bypoints didn't work well Geometry	5	1016	January 18, 2019