Modify the elevation of a polyline

[mzjensen]

@WrightEngineering

This deletes and then re-creates a polyline so if you have data attached to it, it could get deleted, just a warning.

I think this could be a lot simpler by just using the Object.Transform node. This post should help.

Modifying an existing block

Hey Andrew, You could use the Object.Transform node for this. The coordinateSystem input can be a little confusing, but here’s how it works. Say you create a coordinate system with it’s origin at (0,0,100) and supply that as the input. This would move the object by 100 units in the Z direction. The transformation would be relative to where the object is currently located, so basically adding 100 units to whatever the current Z value is. The same thing would apply for rotation. If you needed to …