I have repeatedly attempted to apply and adapt a floors existing points to that of a topography above. This used to work, but does not work now.
All l get is this…which forces me to shutdown Revit and start again.
Any ideas welcomed?
I have repeatedly attempted to apply and adapt a floors existing points to that of a topography above. This used to work, but does not work now.
All l get is this…which forces me to shutdown Revit and start again.
Any ideas welcomed?
Uninstall package TurnIntoList.
I have uninstalled ‘TurnIntoList’. Shall this enable the following to work?
The node in the image does not do anything. Any thoughts.
I hate it when a graph works in the past, then does not due to an upgrade.
It’s not likely to work if the floors port does not receive any input.