Wall with different start and end height

[Tmr]

Ok so I managed to do it by using the solution from one of my other topics. (see link)

Cutting parts off a Floor using dynamo

Unfortunately editing the floor loops doesn’t allow you to “notch” the geometry. However, using @jacob.small’s logic you can do this with spring nodes and clockwork. (I did have a little fun with the “notching” that I used.) The workflow in Dynamo: [image] The Result in Revit: [image] And some sample files if anyone else wanted to have a go with it. GenerateVoidFamily.dyn (24.7 KB) VoidFloorWithFamily.rvt (532 KB)

This is working for me!