Specify coordinates at point using dynamo

[nathan_torggler]

Hi there,
do you now by chance if it is possible to access the Revit command “Specify coordinates at point” with the dynamo API?

[RMohareb]

Edit site location

@jacob.small Thank you for your reply, I understand that thank you. what i need to change by dynamo this point which i can change it manual (is it Internal point ??) It is different than base point [image]

@nathan_torggler
this node in Brimoahreb pak rev7 _(not publich yet) if you need it i can send it to you by email

[nathan_torggler]

Thank you. PM sent! Here you soon.