Join Forms (JoinGeometry) in Family Document [RevitAPI]

Developers
23

Hi Juan,
Sorry, I’ve been very busy lately and haven’t been on the forum.
Unfortunately I haven’t found a solution either.
In my case, however, it worked to increase the number of profiles and then create a volume/loft from all the collected cross-sections - this way I don’t have to join them.

Thank you very much for your answer and your work.
Patrick

24

Hi @patrick.weis ,
Thank you for your reply.

Yeh, that´s a workaround but you need to increase the number of cross-sections so much and if you end up lofting all of them, if you have a geometry with a sharp “corner” or change of direction, the loft will be following a nurbs interpolating. Same as a spline does.