My goal is to create a script that creates wall finishes in a selection of rooms, depending on the wall type. Concrete walls get a thick plaster, masonry walls get a thin plaster. I was able to match a finish wall type to the already existing construction walls (still need to do some more work on …

Apparently this node from Wombat package does the trick! [image]

@jacob.small Yes this worked. [image] My savior once again, thank you! :slight_smile:

Looking forward to that OG thread update… or even better an AU or Community Conversation proposal. :slight_smile:

@jacob.small Haha when and where? But about the script, I’m going to need to switch to the room boundaries for the curves since walls usually span multiple rooms so the wall faces are not gonna work… But I have no idea how to move the curves from the room boundaries in the correct direction to com…

[image] Laura_BIMChick: Haha when and where? Autodesk University is here: https://www.autodesk.com/autodesk-university/conference/call-for-proposals Community Conversations proposal is here: https://autodeskfeedback.az1.qualtrics.com/jfe/form/SV_6ofmUCJ943S4BBI For the room boundaries metho…

I’ll take a look at it. I was able to do the polycurve and explode it. I’m able to get the offset value. Joining in the corners I also already have covered, but trimming would be better, is this possible in dynamo? But I have no idea how to offset the curves in the right direction - towards the …

Using the negative value should work once you make the polycurve. :slight_smile:

So offset the polycurve before exploding?

Never mind, kinda figured it out: I fed the roomboundary curves into the node instead but they match with the direction of the room bounding elements that create the curves and removed the distance, so this works! [image]

Okay so I didn’t figure it out, as I’m testing the script on a bigger scale I’m running into more trouble/problems… So first thing, right now the script can only use walls, and not columns… So I’m gonna have to throw them into the mix somewhere/somehow… [image] Second, offset for freestanding/in…

Creating Wall finish depending on Wall Type

Revit

jacob.small March 14, 2022, 12:30pm 2

An idea: add 1/2 of the thickness of the plaster to the distance of the offset in the code previously discussed here Wall location curve - #24 by jacob.small ?

Topic		Replies	Views
Creating wall finishing with room height and room boundary Revit dynamo	24	992	May 24, 2023
Creating wall finishes from rooms Revit dynamo , springs	7	4497	February 27, 2018
Create Wall Finishes With Dynamo Packages	28	6045	August 17, 2017
Create new wall for finishings issue Revit dynamo	0	457	November 23, 2019
Create Wall Finish From Room Boundry And Offset The Finishing Wall with the Slab Thicknes From Linked Model Revit revit , dynamo	2	620	July 3, 2023

Creating Wall finish depending on Wall Type

Related topics