Check if Revit wall exists at point

[Tom_Kunsman]

Welcome to the Dynamo forums.

What have you tried to create so far? Do you have any attempts that you can share? Any warnings that come up?

Please check the following forum posts that may help you:

How to get X,Y,Z Point from wall

Hi all, I am placing one family by manually. I try to create a automatic family placement inside of the opposite wall. But I get only centre point of the room only. How to get the X,Y,Z point from opposite wall. [Transmitter]

Cut wall at point

Hello Everyone. Well, here is what I would like to do : I’d like to cut a wall at a specific point. I tried many ways to do this, but is there a fonction (like the one in revit) so we cut a selected wall at a specific point?