Cap Open Ends For Duc

knnk March 12, 2018, 9:01am 1

Hello everyone. This is my first post, I hope not to be wrong and my English is not good.
Is there any way to automatically put Cap Open Ends For Duct from dynamo?
Thanks in advance

Topic		Replies	Views
Looking for pointers with offsets on ductwork DesignScript	0	59	March 17, 2024
Manipulating MEP Fabrication Parts Revit revit , mep , fabrication , dynamo	0	369	September 7, 2022
Revit - Automating Reinforcement in Pilecaps using dynamo Revit dynamo	2	1676	May 5, 2017
The MEP side -- needs a LOT of attention! Packages	31	5737	February 20, 2018
Amateur	1	382	April 5, 2017

Cap Open Ends For Duc

Related Topics