Assembly-How to get all view already created

[Einar_Raknes]

I think this one is even closer, it’s about assembly sheets, but the same methods should work for views as well.

Modifying Assembly Sheets only

Not sure if this topic belongs here but I’ll ask the question to get started anyway. I am looking for some advice from those who have done this before . I needing to rename sheets but ONLY ones for assemblies. I do have a graph setup in Dynamo that does just this, BUT if I have any additional sheets in my project, it gets ALL of them. I think I could add a parameter to my assembly sheet and filter by that parameter, but does anyone have any other suggestions/ideas on how to approach this wit…