Set viewport location based on other. But using crop region instead

[gerhard.p]

Hello @1bitBoolean,

I also struggled with viewport sizes when placing views on sheets, there is only one real solution. You have to hide all annotation categories in the view. Then the viewport will have a consistant distance of exactly 0.01ft from the cropbox.
Later you can activate annotations again.

It is a good solution in my opinion.

Model element locations on sheet

Hi all, I ran into a problem concerning sheets and model elements. I would like to place elements, like symbols and views, on my sheet on the position, or related to the position, of certain model elements. In this case, I have some beams and want to place an arrow in the middle of it This arrow should point towards a section view concerning the beam. The situation is sketched below: [image] What I know is the Cropbox size and position in the model coordinate system. What I also know is s…