Hi,
its friday and i don’t understand this problem;)
Could some tell me, why the slope is not set correct and how i can fix this?
I try to set the slope to (10°,45°,10°,45°) but in Revit i get the result: (9.9,38.15,9.9,38.15)
Here are some links about this topic…but I do not understand it:(
<span lang=“EN-US”>I have a Revit project with a simple roof element with two sloped planes (see picture). I’m trying to get the slope value of the roof element so I can use this to perform some calculations, but I ran into some (probably small) issues. </span>
<span lang=“EN-US”>The slope value in this case is 42 degrees. The Element.GetParameterValueByName node however reports a value of 51.584. This probably is a conversion of some sort, but I just can’t figure out where this value comes fro…
http://thebuildingcoder.typepad.com/blog/2010/08/slope-is-slope-not-radians.html