Is there any way to automatic cut pressure pipes according to the cut length (6 m) on plan or breaking it by intersecting lines

Hi Looking at this [image] Pressure Pipe Runs & Add Fittings Civil3D @Ahmed.Kamal.Moussa Here is your solution. Make sure the only alignments being fed into python are the pressure pipe network alignments. AddTees.dyn (75.9 KB) AddTees-postScript.dwg (1017.8 KB) AddTees-preScript.dwg (1008.0 KB)

Automatic Break of the pressure pipes by it cut length on the plan CIvil 3D

Civil 3D

hosneyalaa February 23, 2023, 8:09pm 2

Looking at this

Topic		Replies	Views
Pressure Pipe Runs & Add Fittings Civil 3D dynamo , civil3d	33	4618	September 27, 2024
Civil 3D Pressure Pipe Network Nodes Problem! Civil 3D	28	3114	February 2, 2022
Create Lv network using pressure pipe and make pipe Run For all pipe Civil 3D python , dynamo	7	197	April 23, 2026
PressurePipeRun.ByObject with fittings Civil 3D python , geometry , dynamo	0	123	July 16, 2024
Is there any node available to break a civil 3d pipe Civil 3D dynamo	9	997	February 20, 2025

Automatic Break of the pressure pipes by it cut length on the plan CIvil 3D

Related topics