# Section view along curve **URL:** \ **Category:** Revit\ **Tags:** dynamo\ **Created:** [March 20, 2020, 11:28pm UTC](https://forum.dynamobim.com/t/section-view-along-curve/48300 "2020-03-20T23:28:06Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![milan.nemec](https://avatars.discourse-cdn.com/v4/letter/m/41988e/32.png) [@milan.nemec](https://forum.dynamobim.com/u/milan.nemec)\ **Post date:** [March 20, 2020, 11:28pm UTC](https://forum.dynamobim.com/t/section-view-along-curve/48300/1 "2020-03-20T23:28:06Z")
Hello, I want to create section view on curve. I extract V isocurve and create plane in parameter on it. Then I create coordinate system on plane. I want to create section view by this plane or coordinate system, but I always got error. Min and max point are generated by coordinate system. Have You any idea where is error ? ![section view error](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/3/7/376a77743f72ecc63a4cb6cbd39568b395860f30.png) ![section view](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/a/9/a9fb5780cc3ec3e29366c5445a33f1a7ab769cb8.png) ---
**Author:** ![Kulkul](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.dynamobim.com/kulkul/32/49801_2.png) [@Kulkul](https://forum.dynamobim.com/u/Kulkul)\ **Post date:** [March 24, 2020, 7:05pm UTC](https://forum.dynamobim.com/t/section-view-along-curve/48300/2 "2020-03-24T19:05:13Z")
Hi @milan.nemec Refer this post: > [@Creating Curved Cross Section, Bridge Engineering](https://forum.dynamobim.com/t/creating-curved-cross-section-bridge-engineering/7710/7): > > You could split your bridge centre line into a series of chords, create a section at each chord, and finally place the sections next to each other on a sheet, to get a “developed section”. In this case I snapped the sections together by their crop box, but I’m pretty sure you can create some custom logic that snaps them automatically.