Isocurves spacing and parameter adjustment

hi. how can I adjust the spacing between these isocurves by myself. and how can I have a different number of curves in both direction?


The spacing is dependent on the parameters you provide. You’re providing 6 evenly spaced parameters so that’s what you get. If you want different spacings in different directions then you need to provide two sets of parameters.

how can i provide two sets of parameter.
ByIsoCurveOnSurface.dyn (23.6 KB)

A list of parameters goes with one direction. You’re providing a list of directions but still only one list of parameters. You can provide a list of two sets of parameters (one for each direction).

1 Like

List levels can solve this.

1 Like