Hello everyone,
I am new to using Dynamo, and lately, I have been trying to automate some of my modeling tasks. However, I’ve run into a problem.
I am trying to connect these stairs to the exact middle of the trapezoidal wall shown in my floor plan view, but I can’t seem to get them to align properly.
Could someone please share a method or workflow to achieve this?
Thank you!
Hi Muhannad, welcome to the forum 
Please take the time to review How to get help on the Dynamo forums
How often do expect to place stairs in this situation? It seems a highly specific use case for automation. If its a one off just use a dimension from the centreline of the stairs to the junctions on either side and set the equal constraint.
Thank you, I didn’t know Revit can use the dimension tool between two point the blue dot was too small to see.
