# Dynamo way to inform the user it is complete?

**URL:** <https://forum.dynamobim.com/t/dynamo-way-to-inform-the-user-it-is-complete/27147>\
**Category:** Uncategorized\
**Created:** [October 12, 2018, 8:28pm UTC](https://forum.dynamobim.com/t/dynamo-way-to-inform-the-user-it-is-complete/27147 "2018-10-12T20:28:40Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![mdhutchinson](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.dynamobim.com/mdhutchinson/32/54611_2.png) [@mdhutchinson](https://forum.dynamobim.com/u/mdhutchinson)\
**Post date:** [October 12, 2018, 8:28pm UTC](https://forum.dynamobim.com/t/dynamo-way-to-inform-the-user-it-is-complete/27147/1 "2018-10-12T20:28:40Z")

</div>

When running a selected Dynamo Graph from Dynamo Player, is there a way to inform the user of successful run/finish of a Dynamo Graph… perhaps with some Info shown to the user?

---

<div class="post-metadata">

**Author:** ![Steven](https://sea2.discourse-cdn.com/flex022/user_avatar/forum.dynamobim.com/steven/32/112504_2.png) [@Steven](https://forum.dynamobim.com/u/Steven)\
**Post date:** [October 12, 2018, 8:59pm UTC](https://forum.dynamobim.com/t/dynamo-way-to-inform-the-user-it-is-complete/27147/2 "2018-10-12T20:59:12Z")

</div>

it does?

Before run  
 ![image](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/7/0/708ade1a87a7787f96eb3084001c38a69d7a65dd.png)

While running  
 ![image](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/f/3/f3c06264878da6f9edbb4b876758ef2f1a3f9f80.png)

After run  
 ![image](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/c/2/c269a3d6cb6bbe01980d65821de258a392f526f8.png)

Run complete with errors. This one could use some work because it will say there was a problem if the graph completed, did not complete or somewhat completed. Some nodes just error. I try to make it a point to fix any and all errors so this will only show if a real error takes place. If I cannot stop the error I dont like to use the player.  
 ![image](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/9/3/9325c7812feb14de07289063e99992ee9244135f.png)

If you are running Revit 2018.2 or newer then you can change parameters from the player and see outputs. If you change the name of a watch node it will show once the script has ran. In this case it passes some pre scripted text to the uses to let them know if there are duplicates.  
 ![image](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/3X/f/b/fbf3b0c0cae05b8b3f3259735c0357bf3759395a.png)

Hope this helps,