# Crop Region by curve **URL:** \ **Category:** Developers\ **Tags:** revit\ **Created:** [June 19, 2016, 1:49pm UTC](https://forum.dynamobim.com/t/crop-region-by-curve/4607 "2016-06-19T13:49:06Z")\ **Posts on this page:** 1\ **Showing post:** 19
**Author:** ![jup](https://avatars.discourse-cdn.com/v4/letter/j/0ea827/32.png) [@jup](https://forum.dynamobim.com/u/jup)\ **Post date:** [September 29, 2016, 4:44pm UTC](https://forum.dynamobim.com/t/crop-region-by-curve/4607/19 "2016-09-29T16:44:59Z")
However it hasn’t solved the main problem. I am struggling to place views on sheets, i was trying to find n alternate way to crop the views to see if they would pack onto the sheets, but alas I have the same error. I have noticed this has also been recently commented on in the following thread. > [@Issue placing views on sheets](https://forum.dynamobim.com/t/issue-placing-views-on-sheets/6368): > > [image] Dynamo is giving me a issue when I try to place a cropped view (trough scope box) into a sheet. It’s say that the views is too big to be placed inside the sheet. I think that dynamo is computing the whole floor view, not the cropped one. Any suggestions? Thanks! Previously i had the same error, it seemed the view was too large for the sheet. However now, even the numbers are smaller so i’m a bit confused … ![](https://us1.discourse-cdn.com/flex022/uploads/dynamobim/original/2X/d/d8e23e36be86c66fbf1d55b709823604d2b47266.png) --- _[View the full topic](https://forum.dynamobim.com/t/crop-region-by-curve/4607)._